Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Valor Thermo Current Cable 5119813

Valor

Valor Thermo Current Cable 5119813

Thermo current cable, part 5119813, for Valor gas boilers and Valor Group spare parts.

At a glance

  • Also known as 1118655
Manufacturer part no.
5119813
Showing prices

£34.56

£28.80 ex. VAT · VAT at 20%

Available to order · 4 working weeks
Available to order · 4 working weeks
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Valor 5119813 is a thermo current cable used on Valor gas boilers. It carries the flame sensing (ionisation) signal between the burner electrode and the boiler's control board, allowing the PCB to confirm that a flame is present and keep the gas valve open. It is supplied as a Valor Group spare part.

Signs this part needs replacing

  • The boiler lights and then locks out within a few seconds because no flame signal is detected.
  • Repeated ignition attempts with the burner visibly alight but the control board not registering a flame.
  • Intermittent lockouts that clear on reset and return once the boiler has run for a while.
  • Visible heat damage, brittle or cracked insulation on the cable, particularly near the electrode end.
  • Corroded, loose or discoloured spade terminals at either end of the lead.

Before you order

  • Confirm the boiler model against the manufacturer's parts list to verify that 5119813 is the correct lead.
  • Compare the existing cable's terminal type and routing with the replacement before fitting.
  • Isolate the electrical supply and shut off the gas before removing the old cable.
  • Check the electrode and its lead connection for contamination or damage, as these can mimic a faulty cable.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.