Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal Thermostat Sensor Harness Classic 137658

Ideal

Ideal Thermostat Sensor Harness Classic 137658

Ideal thermostat sensor and harness for Classic FF and Classic FF LX boilers, regulating temperature for safe, efficient operation. Part 137658.

At a glance

  • Part type: Sensors
  • Also known as 1176560
Manufacturer part no.
137658
GC number
308-357
Showing prices

£92.62

£77.18 ex. VAT · VAT at 20%

Available to order · 3 working days (HRP Trade)
Available to order · 3 working days (HRP Trade)
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Ideal Thermostat Sensor & Harness Classic is a temperature-sensing assembly used on Ideal Classic FF and Classic FF LX boilers. The sensor reads boiler temperature and feeds that signal back to the control circuit, which modulates firing to hold the appliance at its set point. It is supplied as a sensor with its wiring harness attached, so the connection back to the control board is made in one piece.

Signs this part needs replacing

  • The boiler runs but does not reach or hold its set temperature, or cycles on and off more often than usual.
  • Heating or hot water output is erratic, with the appliance cutting out before the system is up to temperature.
  • The boiler locks out or shuts down shortly after firing, with a temperature-related fault indicated.
  • The sensor probe or its harness shows heat damage, brittle insulation, chafing or a broken conductor at the plug.
  • Temperature readings at the boiler disagree with the actual flow and return temperatures measured on the pipework.

Before you order

  • Check the GC number on the appliance data badge against the compatibility list, as the same boiler range was built in several variants.
  • Note the alternative number 1176560 when cross-referencing against older documentation or stock records.
  • Inspect the sensor pocket and any sealing washer at the same time, as these are disturbed when the probe is removed.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.