Stuart Turner
Stuart Turner SPU 130 Mini Pressurisation Unit
Stuart Turner SPU 130 Mini pressurisation unit for maintaining pressure in sealed heating systems.
£620.64
£517.20 ex. VAT · VAT at 20%
Same-day dispatch
Ordered by 4pm Mon–Fri, 10:30am Sat.
30-day returns
Unused, in original packaging.
What it is
The Stuart SPU 130 Mini is a pressurisation unit manufactured by Stuart Turner. It is designed to maintain and top up pressure within a sealed heating system, replacing manual filling arrangements with automatic pressure control. The unit is listed within the boiler category of the manufacturer's range.
Signs this part needs replacing
- System pressure falls repeatedly and does not hold after manual topping up
- The unit runs continuously or cycles without bringing the system up to pressure
- No pressure increase is seen at the system gauge when the unit operates
- Water is found leaking from the unit body, connections or overflow
- Fault or alarm indication is shown on the unit
Before you order
- Check the existing unit's model number and confirm it matches the SPU 130 MINI
- Confirm the system is a sealed system that the unit is intended to serve
- Check the pipework connections and electrical supply arrangements of the existing installation against the replacement unit
- Confirm any associated components in the pressurisation arrangement are serviceable before fitting
No specification data held for this part.
| Make | Model / assembly | Reference | Years | Fitment |
|---|---|---|---|---|
| SPECIAL OFFERS Stuart Turner | — | — | — |
Documents & drawings
Everything we hold for this part. Where a document exists but we don't hold it, the technical team will source it from the manufacturer — usually the same working day.
No documents held for this part. The technical team will source them from the manufacturer — usually the same working day.
No technical questions yet for this part.
Not sure which part?
Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.