Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal Thermistor Sensor BI1001 117 172496

Ideal

Ideal Thermistor Sensor BI1001 117 172496

Ideal thermistor sensor 172496 for Mini and Europa boilers, raising circuit resistance as temperature drops. Fits 22 Ideal models.

At a glance

  • Part type: Thermistor sensor
  • Also known as SENSOR-BI1001-117, 1178842, N0247-C
Manufacturer part no.
172496
GC number
164-026
Showing prices

£23.99

£19.99 ex. VAT · VAT at 20%

Available to order · 1-2 working days
Available to order · 1-2 working days
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Ideal thermistor sensor 172496 is a temperature-sensing component used in Ideal Mini and Europa boilers. It works by increasing circuit resistance as temperature falls, giving the printed control board (PCB) a resistance reading it uses to decide whether heat output should rise or drop. The sensor therefore sits at the centre of the boiler's temperature regulation loop.

Signs this part needs replacing

  • Boiler temperature swings between too hot and too cool instead of holding steady
  • Domestic hot water runs hot then cold, or heating output is erratic
  • Boiler locks out or shuts down shortly after firing
  • Fault codes relating to temperature sensing or flow/return temperature appear on the display
  • Resistance readings from the sensor fall outside the expected range for the measured temperature

Before you order

  • Check the GC number on the appliance data badge against the GC numbers listed in the compatibility table before ordering
  • Confirm the alternative numbers 1178842 and N0247-C match the sensor currently fitted
  • Inspect the sensor seal or O-ring at the same time and replace it if it is hardened or damaged

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.