Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal Sensing Lead Super Plus DBI 110535

Ideal

Ideal Sensing Lead Super Plus DBI 110535

Ideal 110535 sensing lead for Ideal Commercial Super Plus and Module Super Plus DBI boilers, carrying the flame sensing signal to the control board.

At a glance

  • Part type: HT lead / sensing lead
  • Also known as 1175416
Manufacturer part no.
110535
Showing prices

£17.59

£14.66 ex. VAT · VAT at 20%

Available to order · 5-7 working days
Available to order · 5-7 working days
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Ideal 110535 is a sensing lead used on Ideal Commercial Super Plus and Module Super Plus DBI boiler ranges. It carries the flame sensing signal between the sensing electrode and the boiler control board, letting the controls confirm that a flame has been established and shut the burner down safely when it has not. The lead is supplied as a single replacement item and is listed under the Ideal Commercial Boiler Spares range.

Signs this part needs replacing

  • The boiler runs through its ignition sequence but locks out before a flame is proven.
  • Repeated ignition lockout fault codes appear on the appliance display.
  • Flame detection is intermittent, so the burner drops out part way through a demand.
  • The lead insulation is brittle, cracked or heat-damaged where it passes close to the burner.
  • Terminals at the electrode or control board end are loose, corroded or show signs of arcing.

Before you order

  • Check the GC number on the appliance data badge against 41-415-68 or 41-415-69.
  • Confirm the appliance model in the compatibility list, as this lead is specific to the Super Plus and Module Super Plus DBI ranges.
  • Inspect the sensing electrode and its sealing washer at the same time; a worn or contaminated electrode can produce the same symptoms as a faulty lead.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.