EOGB HT Cable 30m Coil Black Standard Type X02-RM77-30

This is an EOGB HT Cable supplied as a 30m coil in black, standard type. It is a high tension ignition cable used to carry the spark voltage from the ignition transformer or control unit to the electrode on EOGB boiler and burner assemblies.

• The burner fails to ignite despite the ignition transformer and control unit operating.
• Intermittent lockout that clears on reset, suggesting a breakdown in the ignition circuit.
• Visible cracking, chalking or scorching of the cable sheath, particularly near the electrode end.
• Spark arcing to earth or to the burner body instead of at the electrode tip.
• Insulation resistance readings that fall away when the cable is flexed or warmed.

• Confirm the appliance is an EOGB unit and identify the ignition lead routing and required length before cutting from the coil.
• Check the terminal or connector arrangement on both the transformer/control end and the electrode end, as these are made up on site from the coil.
• Inspect the existing cable for the voltage rating and sheath type fitted, and match it with the standard type cable offered here.
• Allow for the full run plus any slack needed at service loops when calculating how much cable to take off the coil.