Ideal Sensor Assembly Electronic Thermostat 013248

The Ideal 013248 is an electronic thermostat sensor assembly used on Ideal Commercial boiler ranges. It monitors temperature at its sensing point and feeds that signal back to the boiler's control circuit, allowing the appliance to regulate firing and shut down safely when the set point is reached. It is a direct replacement for the same sensor used across the Concord CX and CX P commercial families.

• Boiler runs but never reaches the temperature set on the control thermostat
• Temperature displayed or delivered is noticeably higher or lower than the set point
• Frequent cycling, short firing periods or erratic burner behaviour
• Boiler locks out or shuts down without an obvious flame or gas fault
• Overheating symptoms traced to a sensor reading that does not match a measured pipe or flow temperature

• Confirm the appliance model and GC number against the compatibility list before ordering, as the same sensor is used across several Concord variants.
• Check the existing sensor's part number or the alternative number 1170466 on the old component where it is legible.
• Inspect any seal, washer or gasket at the sensor pocket or mounting point and renew it if it is perished or compressed.