Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Baxi 7690352 Combi 33kW LMU 34 Printed Circuit Board - 5 Coil

Baxi

Baxi 7690352 Combi 33kW LMU 34 Printed Circuit Board - 5 Coil

Baxi 7690352 printed circuit board for Combi 33 5 Coil appliances, controlling ignition, fan, pump and safety sequencing.

At a glance

  • Part type: Printed Circuit Boards (PCB)
  • Also known as 7625864082905, BAXI7690352, 263650835553, 43375518
Manufacturer part no.
7690352
GC number
H92-801
Showing prices

£252.72

£210.60 ex. VAT · VAT at 20%

In stock
Order within 2h 39m for same-day dispatch
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Baxi 7690352 is a printed circuit board (PCB) supplied for the Baxi Combi 33 5 Coil appliance. It is the main control board, handling the sequencing of ignition, fan operation, pump running and the safety interlocks that keep the boiler working within its design limits. As a factory-specified board it carries the connector layout and software configuration matched to this combi model.

Signs this part needs replacing

  • The boiler locks out repeatedly and will not complete an ignition sequence.
  • No heating or hot water demand is registered, with the display dead or showing no response to controls.
  • Fan, pump or diverter operation becomes erratic, or the boiler runs through a start cycle and stops.
  • Fault codes appear on the display that clear only temporarily after a reset.
  • Visible damage on the board itself, such as scorching, a blown track or a swollen capacitor.

Before you order

  • Confirm the appliance model and GC number from the data plate, then match them against the compatibility list on this page.
  • Check the part number printed on the existing board against BAXI7690352 before removal, as board revisions are model-specific.
  • Inspect the wiring loom, connectors and any seals disturbed during access, and replace them if they show heat damage or brittleness.
  • Work on the appliance should be carried out by a competent engineer, with the electrical supply isolated before the board is unplugged.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.