Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Vaillant Printed Circuit Board 0010028086

Vaillant

Vaillant Printed Circuit Board 0010028086

Printed circuit board for Vaillant ecoTEC Plus and ecoTEC PRO gas boilers, covering VU, VUW and VUI variants.

ConditionNew

At a glance

  • Also known as 1383490
Hanicks code
0010028086
Manufacturer part no.
0010028086

The Hanicks code is specific to the selected condition. Manufacturer part no. and barcode are shared by every condition.

Showing prices
Choose condition

£357.74

£298.12 ex. VAT · VAT at 20%

Available to order · 3 working days (HRP Trade)
Hanicks code
0010028086
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Vaillant 0010028086 is a printed circuit board for Vaillant ecoTEC Plus and ecoTEC PRO gas boilers. It is the control board that governs the boiler's operating sequence and carries fault and status information to the display. It is listed for VU, VUW and VUI variants across the ecoTEC range.

Signs this part needs replacing

  • The boiler does not respond to a heating or hot water demand
  • The display is blank, dim or unresponsive
  • Repeated lockouts or fault codes that clear only temporarily
  • Fan, pump or ignition sequence running erratically
  • Intermittent operation that changes when the board or its plugs are disturbed

Before you order

  • Confirm your appliance model and GC number against the fitment list above.
  • Note the revision suffix on your appliance (for example R1, R4 or R6) and check it against the list.
  • Check the part number printed on the existing board before ordering.
  • Isolate the boiler from the electrical supply before removing or fitting the board.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.