Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Potterton Potentiometer Wiring Harness Assembly 840072

Potterton

Potterton Potentiometer Wiring Harness Assembly 840072

Potterton potentiometer wiring harness assembly, part 840072, for Kingfisher MF gas boilers.

At a glance

  • Appliance family: Kingfisher MF
  • Also known as 1124519
Manufacturer part no.
840072
GC number
E02-380
Showing prices

£55.42

£46.18 ex. VAT · VAT at 20%

Available to order · 3 working days (HRP Trade)
Available to order · 3 working days (HRP Trade)
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Potterton 840072 is a potentiometer wiring harness assembly for the Potterton Kingfisher MF range of gas boilers. It connects the potentiometer to the boiler's control circuit, carrying the signal used to set and regulate the appliance's operating temperature. The assembly is supplied as a complete loom for straightforward renewal where the existing wiring or connector has degraded.

Signs this part needs replacing

  • Temperature control has no effect on boiler output or behaves erratically
  • The boiler fails to respond when the potentiometer is adjusted
  • Visible damage to the loom, such as cracked insulation, scorching or exposed conductors
  • Loose, corroded or intermittent connections at the harness plugs
  • Fault tracing points to a break in continuity through the potentiometer circuit

Before you order

  • Confirm the appliance model against the fitment list above before ordering
  • Check the existing harness and potentiometer for damage so the correct component is replaced
  • Inspect the connector terminals for corrosion or heat damage that may also need attention
  • Isolate the boiler electrically before carrying out any inspection or replacement work

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.