Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal 173799 Printed Circuit Board 25E

Ideal

Ideal 173799 Printed Circuit Board 25E

At a glance

  • Part type: PCB Printed Circuit Board / Control Boxes
  • Appliance family: Ideal Classic Combi and Classic FF
  • Also known as IDEAL173799
Manufacturer part no.
173799
GC number
H20-882
Showing prices

£144.00

£120.00 ex. VAT · VAT at 20%

In stock
Order within 2h 42m for same-day dispatch
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Ideal 173799 is a printed circuit board used in Ideal domestic gas boilers, listed by the manufacturer under the PCB and control box part group. It carries the 25E designation and sits at the centre of the appliance's electrical control system, handling burner sequencing, ignition timing, temperature regulation and the safety interlocks that shut the boiler down when a fault is detected. It is a direct replacement board for the units listed in the compatibility table below.

Signs this part needs replacing

  • The boiler locks out repeatedly and will not reset, or resets only briefly before failing again.
  • No response from the controls: the boiler does not attempt to fire when there is a call for heat or hot water.
  • The display or indicator LEDs are dead, flickering or showing an error code that does not clear.
  • The fan, pump or gas valve runs erratically, or the boiler cycles on and off without reaching temperature.
  • Visible damage on the board itself, such as scorching, a blown track or a swollen capacitor.

Before you order

  • Confirm the model and GC number of the appliance against the compatibility list before ordering, as board variants are not interchangeable across the range.
  • Check that the part number printed on the existing board matches 173799, and note any alternative number shown on the old component.
  • Isolate the electrical supply and follow the manufacturer's wiring diagram when fitting; boards are polarity and connector-position sensitive.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.