Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Vokera Main Burner 7623

Vokera

Vokera Main Burner 7623

Vokera 7623 main burner (Polidoro NP7) for Mynute 10 SE, 12E, 14 SE, 14E, 14/48 and 20 SE gas boilers.

At a glance

  • Part type: main burner
  • Appliance family: Vokera Mynute
  • Also known as 1531279
Manufacturer part no.
7623
GC number
379-614
Showing prices

£109.68

£91.40 ex. VAT · VAT at 20%

Available to order · 1-2 working days
Available to order · 1-2 working days
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Vokera 7623 is a main burner assembly for Vokera Mynute gas boilers, supplied in Polidoro NP7 form. It carries the gas/air mixture across the burner head to produce the flame that heats the appliance's primary water circuit. It is a serviceable combustion component, replaced when the burner head or its ports are damaged, corroded or blocked.

Signs this part needs replacing

  • Yellow, lazy or lifting flame instead of a steady blue flame
  • Soot deposits or blackening around the burner head or heat exchanger
  • Combustion readings outside the appliance's specified range, or a CO/CO2 analyser reading that cannot be corrected by adjustment
  • Visible corrosion, cracking or blocked burner ports
  • Uneven flame pattern across the burner surface

Before you order

  • Confirm your boiler model against the fitment list above, using the model badge and GC number where available
  • Check the burner designation on the existing component matches Polidoro NP7
  • Inspect the burner gasket and seals, and replace them if disturbed during the swap
  • Work on gas-carrying components must be carried out by a competent, registered engineer

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.