Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal Printed Circuit Board Mini 172561

Ideal

Ideal Printed Circuit Board Mini 172561

Ideal Mini printed circuit board (PCB) 172561, the control board for Ideal Europa and Mini boiler models, monitoring sensors, switches and thermostats.

ConditionNew

At a glance

  • Part type: Printed circuit board (PCB)
  • Also known as 1178900
Hanicks code
172561
Manufacturer part no.
172561
GC number
H07-864

The Hanicks code is specific to the selected condition. Manufacturer part no. and barcode are shared by every condition.

Showing prices
Choose condition

£351.82

£293.18 ex. VAT · VAT at 20%

Available to order · 1-2 working days
Hanicks code
172561
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Ideal Mini printed circuit board is the control board that governs the running of the appliance. It reads inputs from switches, thermostats and sensors around the boiler and uses them to manage ignition, firing and modulation. It also carries the safety logic, shutting the boiler down when internal readings point to a fault such as overpressure or a low water level.

This board is supplied by Ideal for the Mini and Europa ranges and is identified by part number 172561.

Signs this part needs replacing

  • The boiler locks out repeatedly and will not reset, or resets only to fail again shortly after.
  • No heating or hot water despite the appliance appearing to power up.
  • Fault codes or lockout indications that point to a control or sensing fault rather than a component in the water or gas circuit.
  • Intermittent running, with the boiler firing and then dropping out without an obvious external cause.
  • Visible damage on the board itself, such as discoloured tracks, scorching or swollen components.

Before you order

  • Check the GC number and model plate on the appliance against the compatibility list to confirm the board is correct for your boiler.
  • Note the alternative and previous part numbers listed below, as older boards may carry a different number on the label.
  • Inspect the board connector plugs and loom for corrosion or heat damage before fitting a replacement, as these can cause the same symptoms.
  • Work on the appliance should be carried out by a competent person, with the boiler isolated from the electrical supply before the board is removed.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.