Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal Limit Thermostat LM7P8508 171950

Ideal

Ideal Limit Thermostat LM7P8508 171950

Ideal limit thermostat 171950 (LM7P8508) for British and Scottish Gas, Classic, Henrad and Optia boilers, cutting the burner at the set maximum temperature.

At a glance

  • Part type: Limit thermostat (LM7P8508 limit stat)
  • Also known as 1178351
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.
Manufacturer part no.
171950
GC number
E58-720
Showing prices

£60.64

£50.53 ex. VAT · VAT at 20%

Available to order · 3 working days (HRP Trade)
Available to order · 3 working days (HRP Trade)
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Ideal limit thermostat, part number 171950, is a temperature sensor and switch assembly used across the Ideal British and Scottish Gas, Classic, Henrad and Optia boiler ranges. Built-in sensors monitor boiler temperature continuously, and the switch stops the appliance operating once the selected maximum temperature is reached. It is supplied as an LM7P8508 limit stat and works as an overheat safeguard rather than a user-facing room or cylinder control.

Signs this part needs replacing

  • The boiler locks out or shows a fault shortly after firing
  • Repeated overheat trips that need a manual reset
  • Heating or hot water cuts out well before the set temperature is reached
  • The burner continues to run past the limit temperature
  • Intermittent operation as the thermostat ages and the switch drifts

Before you order

  • Check the GC number on the appliance data badge against the compatibility list before ordering.
  • Earlier numbers 1178351 and 113200 identify the same thermostat.
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.