Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Thorn Limit Safety Thermostat 402A043

Thorn

Thorn Limit Safety Thermostat 402A043

Thorn limit safety thermostat 402A043 for Apollo gas appliances, monitoring boiler temperature and cutting the burner at the set limit.

At a glance

  • Part type: Thermostats & Thermistors
  • Appliance family: Thorn Apollo
Manufacturer part no.
402A043
GC number
382-396
Showing prices

£28.80

£24.00 ex. VAT · VAT at 20%

In stock
Order within 2h 40m for same-day dispatch
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Thorn limit safety thermostat 402A043 is a temperature-sensing control used on Thorn gas appliances. It monitors the boiler temperature and interrupts the burner when the set limit is reached, so the appliance shuts down rather than overheating. The part belongs to the Thorn Apollo appliance family and is listed under the Thermostats & Thermistors category.

Signs this part needs replacing

  • The boiler locks out or shuts down shortly after firing, with no obvious flame or ignition fault.
  • The appliance runs hotter than the temperature set on the control, or the control has no effect on burner operation.
  • The boiler will not restart until it has cooled, then repeats the same shutdown cycle.
  • The thermostat requires repeated manual resets to keep the appliance running.
  • Heat output stops altogether while the pump and other controls continue to run.

Before you order

  • Check the GC number on the appliance data badge against the compatibility list to confirm the correct variant.
  • Confirm the appliance model, for example Apollo 15/30, 30/50 or 40, before ordering.
  • Note the position and wiring of the existing thermostat before removal so the replacement is fitted the same way.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.