Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Sime Ionisation Lead 6285002

Sime

Sime Ionisation Lead 6285002

Sime 6285002 ionisation lead, 1100mm long, for Sime Brava DGT He25, He30 and He35 boilers.

At a glance

  • Part type: Ionisation lead
  • Appliance family: Sime Brava DGT
  • Also known as 8922368
Manufacturer part no.
6285002
Showing prices

£6.59

£5.49 ex. VAT · VAT at 20%

Available to order · 7 working days
Available to order · 7 working days
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Sime 6285002 ionisation lead is a 1100mm ionisation lead for Sime boilers. It connects the burner's flame-sensing electrode to the boiler's control board. The control board uses this signal to confirm that the burner has lit and is still alight.

Signs this part needs replacing

  • The boiler ignites, then shuts down shortly afterwards with a flame-failure fault.
  • The boiler fails to light and locks out during ignition.
  • Lockouts happen intermittently, with no obvious change in heating or hot water demand.
  • The fault recurs after the burner and gas valve have been checked and found to be working.
  • Visible damage, corrosion or loose connections are present on the lead or at its terminations.

Before you order

  • Confirm the boiler model matches one of the listed fits (He25, He30 or He35) using the rating plate or appliance label.
  • Check that the lead length of 1100mm suits the existing installation before fitting.
  • Compare the connections at each end of the existing lead with the replacement before ordering.
  • Test the flame signal and inspect the electrode and burner for contamination, as a faulty burner can cause similar lockouts.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.