Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal Ignition Electrode Kit Istor 173528

Ideal

Ideal Ignition Electrode Kit Istor 173528

Ideal ignition electrode kit (173528) for Elise, Esprit 2, Evo, Isar, Istor, Icos and Mexico boilers, generating the spark that lights the burner.

At a glance

  • Part type: Electrodes and ignitions
  • Also known as IGNITION-ELECTRODE-KIT---PRE-XH, 1179514, N9186
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.
Manufacturer part no.
173528
GC number
H07-664
Showing prices

£32.63

£27.19 ex. VAT · VAT at 20%

In stock
Order within 2h 32m for same-day dispatch
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Ideal ignition electrode kit is a spark electrode assembly used across a wide range of Ideal domestic gas boilers, including the Elise, Esprit 2, Evo, Isar, Istor, Icos and Mexico families. The electrode sits at the burner and produces the high-voltage spark that ignites the gas/air mixture on a call for heat. Flame-detecting electrodes in the same circuit confirm that a flame has established, so the boiler does not keep supplying gas without ignition.

Signs this part needs replacing

  • The boiler attempts to fire but there is no spark at the burner, or the spark is weak and intermittent.
  • Repeated ignition attempts end in a lockout or fault code rather than a stable flame.
  • The boiler lights and then drops out shortly afterwards, pointing to a poor flame-detection signal.
  • Visible cracking, crazing, carbon tracking or a burnt, eroded tip on the electrode.
  • Damaged or brittle insulation on the electrode lead where it passes close to hot surfaces.

Before you order

  • Check the GC number and model badge on the appliance against the compatibility list, as this kit covers a large number of Ideal models.
  • Cross-check the alternative numbers 1179514 and N9186 against any number printed on the old electrode or its packaging.
  • Inspect the electrode lead and any burner gasket or seal at the same time, as these are commonly disturbed during replacement.
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.