Gledhill
Gledhill Stainless Lite Plus Indirect 250Ltr EE Unvented Cylinder
Gledhill Stainless Lite Plus indirect unvented hot water cylinder with a 250 litre capacity.
£827.52
£689.60 ex. VAT · VAT at 20%
Same-day dispatch
Ordered by 4pm Mon–Fri, 10:30am Sat.
30-day returns
Unused, in original packaging.
What it is
The Gledhill Stainless Lite Plus Indirect 250Ltr EE Unvented Cylinder is an unvented hot water storage cylinder from the Gledhill Stainless Lite Plus range. It stores domestic hot water at mains pressure and is heated indirectly by a separate heat source through an internal coil. The 250 litre capacity suits larger properties with a higher hot water demand.
Signs this part needs replacing
- Water pooling at the base of the cylinder or damp staining on the surrounding floor
- Rust, corrosion or discolouration on the cylinder shell or at the connections
- Reduced hot water flow or pressure at the outlets
- Repeated discharge from the pressure relief valve
Before you order
- Confirm the existing installation is indirect, with a separate heat source feeding a coil
- Check that a 250 litre cylinder will physically fit the space and the access route to it
- Compare your appliance model against the fits list above
- Confirm the installation can be carried out and notified in line with unvented cylinder requirements
No specification data held for this part.
| Make | Model / assembly | Reference | Years | Fitment |
|---|---|---|---|---|
| SPECIAL OFFERS Gledhill Boilermate | — | — | — | |
| SPECIAL OFFERS Gledhill Stainless Lite Plus | — | — | — |
Documents & drawings
Everything we hold for this part. Where a document exists but we don't hold it, the technical team will source it from the manufacturer — usually the same working day.
No documents held for this part. The technical team will source them from the manufacturer — usually the same working day.
No technical questions yet for this part.
Not sure which part?
Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.