Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Danfoss Two-Port Motorised Valve 22mm HP22B 087N6642

Danfoss

Danfoss Two-Port Motorised Valve 22mm HP22B 087N6642

Danfoss HP22B two-port motorised zone valve with actuator, 22mm external compression, 230 V AC, Kvs 5.8 m³/h, part 087N6642.

At a glance

  • Part type: two-port seated valve, complete with actuator
Manufacturer part no.
087N6642
Showing prices

£78.48

£65.40 ex. VAT · VAT at 20%

In stock
Cut-off passed — dispatches next working day
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Danfoss HP22B is a two-port motorised zone valve supplied complete with its actuator. It uses a paddle closure inside a 22mm external compression body to open or close flow through a heating circuit on demand from a room or cylinder thermostat. Part number 087N6642 sits in the Danfoss zone valve range and is used to isolate or release flow to an individual zone of a wet central heating system.

Signs this part needs replacing

  • The zone stays cold while the thermostat is calling, and the pipework either side of the valve remains at the same temperature.
  • The actuator runs but the paddle does not move, so flow is never established or never shut off.
  • A zone overheats because the valve is stuck open and cannot close against the thermostat signal.
  • Water weeps from the compression joints or from the valve body around the spindle area.
  • The actuator buzzes, stalls or fails to respond at all when 230 V AC is applied.

Before you order

  • Confirm the valve body is a 22mm external compression connection and that the existing actuator is a matching H-series unit.
  • Check the supply is 230 V AC at 50/60 Hz before fitting a replacement actuator or complete valve.
  • Note the previous number 087N664200 when cross-referencing an older installation.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.