Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Glow-worm Printed Circuit Board Replacement Kit GLOWWORM2000802731

Glow-worm

Glow-worm Printed Circuit Board Replacement Kit GLOWWORM2000802731

Glow-worm printed circuit board replacement kit, part 2000802731, for Glow-worm boiler electronics and controls. Supplied as a single unit with a 1 year guarantee.

At a glance

  • Part type: Printed circuit board replacement kit
  • Also known as 1331789, N8901
Manufacturer part no.
GLOWWORM2000802731
Showing prices

£251.56

£209.63 ex. VAT · VAT at 20%

In stock
Order within 1h 5m for same-day dispatch
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Glow-worm 2000802731 is a printed circuit board replacement kit, supplied as a complete board assembly for Glow-worm boiler electronics and controls. The PCB is the control centre of the appliance: it reads demand from the room thermostat, programmer and cylinder sensor, then sequences the fan, gas valve, pump and ignition to deliver heating and hot water. When the board fails, the boiler can lose communication with its controls or stop firing altogether, so a like-for-like replacement restores normal operation.

Signs this part needs replacing

  • The boiler does not respond to heating or hot water demand from the controls
  • A blank, dim or unlit display on the appliance fascia
  • Repeated lockouts or fault codes that clear only after a power cycle
  • The pump, fan or diverter does not run when a demand is present
  • A fuse on the board blows again immediately after replacement

Before you order

  • Match the part number 2000802731 against the marking on the board being removed
  • Confirm the appliance model and GC number before ordering, as board variants are not interchangeable across ranges
  • Check whether a gasket, seal or lead set is needed for the specific appliance before refitting

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.