Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal Flue Manifold Cap Kit Rear Sealing 176053

Ideal

Ideal Flue Manifold Cap Kit Rear Sealing 176053

Rear sealing cap kit for the flue manifold on Ideal Logic and Logic+ Heat boilers, supplied under part number 176053.

At a glance

  • Part type: Flue assembly
  • Also known as 1781728
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.
Manufacturer part no.
176053
Showing prices

£19.86

£16.55 ex. VAT · VAT at 20%

Available to order · 3 working days (HRP Trade)
Available to order · 3 working days (HRP Trade)
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The rear sealing cap kit is a flue assembly component for Ideal gas boilers. It seals the rear of the flue manifold, closing off the joint where the manifold meets the appliance casing so that products of combustion stay within the flue path. It is used across the Ideal Logic and Logic+ Heat range and is supplied under part number 176053.

Signs this part needs replacing

  • Flue gas readings drifting outside the expected range on a combustion analysis
  • Visible cracking, hardening or distortion of the existing seal
  • Staining or condensate tracking around the rear of the flue manifold
  • A smell of combustion products near the appliance casing
  • The cap or seal disturbed or damaged during servicing of the flue manifold

Before you order

  • Check the GC number and serial plate on the appliance against the compatibility list before ordering.
  • Confirm the alternative number 1781728 matches the part currently fitted.
  • Inspect the manifold joint while the appliance is open and replace any other seals or gaskets that show signs of deterioration.
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.