Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal 170909 Isar/Icos M Series Fan Kit

Ideal

Ideal 170909 Isar/Icos M Series Fan Kit

At a glance

  • Part type: Fan kit
  • Appliance family: Icos, Isar, Icos System
  • Also known as 1177939, N7918, IDEAL170909
Manufacturer part no.
170909
GC number
E67-494
Showing prices

£253.63

£211.36 ex. VAT · VAT at 20%

In stock
Order within 2h 32m for same-day dispatch
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Ideal 170909 is a fan kit intended for Ideal Icos, Isar and Icos System boilers. The fan draws combustion air into the burner and pushes flue gases out through the flue assembly, so it sits at the centre of the appliance's safe combustion and flueing operation. This kit is supplied as a fan assembly for direct replacement of the original unit.

Signs this part needs replacing

  • The boiler locks out or fails to ignite, with a fan or air pressure related fault code stored.
  • Whistling, grinding or rumbling noise from the fan area during or after ignition.
  • Intermittent operation where the boiler runs and then shuts down shortly after firing.
  • Visible damage, corrosion or debris build-up on the fan impeller or housing.
  • Flue gas readings outside the expected range, or repeated flame failure on start-up.

Before you order

  • Confirm the appliance model and, where available, the GC number against the compatibility list before ordering.
  • Check the existing fan assembly and its mounting gasket or seal, as these may need renewing at the same time.
  • Isolate the electrical supply and the gas supply before removing the existing fan, and follow the manufacturer's service instructions.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.