Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Worcester Bosch Male Double Connector 6.3mm 8716117053

Worcester Bosch

Worcester Bosch Male Double Connector 6.3mm 8716117053

Worcester Bosch 6.3mm male double connector, part 8716117053, for Greenstar i ErP system boilers and other Worcester Bosch appliances.

At a glance

  • Part type: Wiring
  • Also known as 1030999
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.
Manufacturer part no.
8716117053
GC number
J25-228
Showing prices

£1.61

£1.34 ex. VAT · VAT at 20%

Available to order · 5-7 working days
Available to order · 5-7 working days
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Worcester Bosch 6.3mm male double connector is a wiring component used inside Worcester Bosch gas appliances. It provides a 6.3mm male spade connection point for two conductors, forming part of the internal wiring harness that carries low-voltage signals and supply between the boiler's control board, sensors and other electrical components. It is a serviceable spare intended for like-for-like replacement during repair or rewiring work on the Greenstar i ErP system boiler range and other compatible Worcester Bosch models.

Signs this part needs replacing

  • Intermittent operation or a boiler that cuts out when the wiring harness is disturbed
  • A loose, slack or poorly gripping spade terminal that will not stay seated on its tab
  • Discolouration, scorching or brittle insulation around the connector body
  • Corrosion or verdigris on the terminal, causing a poor electrical contact
  • Fault codes or ignition faults traced to a broken or intermittent connection in the harness

Before you order

  • Check the GC number on the appliance data badge against the compatibility list to confirm the correct part for your model.
  • Confirm the existing connector matches the 6.3mm male double configuration before ordering.
  • The alternative number 1030999 may be quoted on older documentation for the same component.
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.