Common
Common Midbras 60XZ1 15mm Compression Stop End
15mm compression stop end from the Midbras range, used to cap and seal the end of a pipe run.
At a glance
- Also known as 1580097
£1.54
£1.28 ex. VAT · VAT at 20%
Same-day dispatch
Ordered by 4pm Mon–Fri, 10:30am Sat.
30-day returns
Unused, in original packaging.
What it is
The Midbras 60XZ1 is a 15mm compression stop end, a brass fitting designed to terminate a pipe run by capping the open end. It seals the line using a compression joint rather than solder or a push-fit connection, making it suitable for dead-ending a length of pipe during installation, alteration or decommissioning work.
Before you order
- Confirm the pipe is 15mm outside diameter, as the fitting is sized for 15mm compression connections.
- Check the part number 60XZ1 against the existing fitting or parts list to ensure the correct item is selected.
- Confirm the pipe material and condition are suitable for a compression joint, and that olives and nuts are available if not already fitted.
- Consider whether a permanent cap is intended, since a stop end blanks the line rather than continuing it.
Compliance
| Alternative numbers | 1580097 |
|---|
No fitment data held for this part.
Documents & drawings
Everything we hold for this part. Where a document exists but we don't hold it, the technical team will source it from the manufacturer — usually the same working day.
No documents held for this part. The technical team will source them from the manufacturer — usually the same working day.
No technical questions yet for this part.
Not sure which part?
Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.