Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Ideal Isolation Valve Assembly CH Flow Pack 175528

Ideal

Ideal Isolation Valve Assembly CH Flow Pack 175528

Ideal 175528 CH flow pack isolation valve assembly for Logic, Code Combi and Keston combination boilers, covering 96 appliance models.

At a glance

  • Part type: Isolation valves, valves general assembly
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.
Manufacturer part no.
175528
Showing prices

£59.76

£49.80 ex. VAT · VAT at 20%

In stock
Order within 2h 9m for same-day dispatch
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Ideal 175528 is a central heating flow pack supplied as an isolation valve assembly for Ideal and Keston combination boilers. It sits on the CH flow connection and lets the heating circuit be shut off and drained independently of the domestic hot water side, which is what makes it useful during servicing, component replacement and system flushing. The assembly is listed under Ideal Spares and is used across the Logic, Code Combi and Keston ranges.

Signs this part needs replacing

  • Weeping or dripping from the valve body or spindle, often leaving scale or water staining around the CH flow connection.
  • The valve will not shut off fully, so the heating circuit cannot be isolated for draining or component work.
  • A stiff or seized handle that will not turn through its full travel.
  • Water tracking down the pipework or onto the boiler casing after the system has been refilled.
  • Repeated pressure loss on the heating side that traces back to the flow connection rather than the rest of the circuit.

Before you order

  • Check the GC number on the appliance data badge against the compatibility list below before ordering, as the same assembly is used across a wide spread of models.
  • Confirm the model and serial details on the boiler, since Ideal and Keston badging changed across the production run.
  • Inspect the existing seals and washers on the flow connection and replace them if they are compressed or damaged before refitting.
  • This part is fitted to a gas appliance; installation must be carried out by a Gas Safe registered engineer.

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.