Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Find parts by applianceTrade account
Vaillant Cable Harness Inverter Compressor 0010034461

Vaillant

Vaillant Cable Harness Inverter Compressor 0010034461

Vaillant cable wiring harness for the inverter compressor on Arotherm PLUS /6 air source heat pumps.

At a glance

  • Part type: cable wiring harness
  • Appliance family: Arotherm PLUS /6
  • Also known as 1392064
Manufacturer part no.
0010034461
Showing prices

£70.00

£58.33 ex. VAT · VAT at 20%

Available to order · 7 working days
Available to order · 7 working days
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Vaillant 0010034461 cable wiring harness connects the inverter compressor within the outdoor unit of an Arotherm PLUS /6 air source heat pump. It carries the electrical supply and control signals between the inverter and the compressor. The harness is a manufacturer-supplied electrical assembly for this appliance family.

Signs this part needs replacing

  • The compressor fails to start or runs intermittently with no obvious mechanical fault
  • Inverter or compressor fault codes appear on the appliance controls
  • Visible damage to the harness, such as chafed, cracked or heat-affected insulation
  • Loose, corroded or discoloured connector terminals at the harness ends
  • Continuity faults or intermittent readings when the harness is tested

Before you order

  • Confirm the appliance model number matches one of the fitments listed above
  • Check the existing harness part number against 0010034461 before removal
  • Inspect the compressor and inverter connectors for damage that may also need attention
  • Isolate the electrical supply and follow the manufacturer's guidance before working on the unit

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.