
Baxi
Baxi Circuit Kit OL PHE Flowswitch 7839660
Baxi circuit kit for the plate heat exchanger flow switch, used on the Auriga HP 33T heat pump.
At a glance
- Appliance family: Baxi Auriga HP
- Also known as 1110251
£621.78
£518.15 ex. VAT · VAT at 20%
Same-day dispatch
Ordered by 4pm Mon–Fri, 10:30am Sat.
30-day returns
Unused, in original packaging.
What it is
The Baxi Circuit Kit OL PHE - Flowswitch is a manufacturer circuit assembly supplied for the plate heat exchanger flow switch on the Baxi Auriga HP range. It forms part of the appliance's flow-sensing circuit, providing the switching signal used by the control system to confirm water circulation through the plate heat exchanger. The kit is identified by part number 7839660.
Signs this part needs replacing
- The appliance reports a flow or circulation fault and will not run
- The flow switch fails to register circulation while the pump is running
- Intermittent lockouts or shutdowns during a heating or hot water demand
- Damaged, chafed or corroded wiring in the flow switch circuit
- The flow switch circuit reads open or short when tested
Before you order
- Confirm the appliance is a Baxi Auriga HP 33T and that the serial number is 240360222 or later
- Check the existing part number 7839660 against the component being replaced
- Inspect the flow switch circuit and its connections before deciding the kit is at fault
Compliance
| Alternative numbers | 1110251 |
|---|
| Make | Model / assembly | Reference | Years | Fitment |
|---|---|---|---|---|
| BAXI AURIGA HP 33T (FROM SERIAL NUMBER 240360222) | — | — | — |
Documents & drawings
Everything we hold for this part. Where a document exists but we don't hold it, the technical team will source it from the manufacturer — usually the same working day.
No documents held for this part. The technical team will source them from the manufacturer — usually the same working day.
No technical questions yet for this part.
Not sure which part?
Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.
