
Andrews
Andrews Siemens HMI to PCB Cable G171
Siemens HMI to PCB cable, part G171, for Andrews water heaters.
At a glance
- Also known as 1823860
£224.10
£186.75 ex. VAT · VAT at 20%
Same-day dispatch
Ordered by 4pm Mon–Fri, 10:30am Sat.
30-day returns
Unused, in original packaging.
What it is
The Siemens HMI to PCB cable is a wiring harness supplied under part number G171 for Andrews water heaters. It carries signals and power between the user interface (HMI) board and the main printed circuit board inside the appliance. The cable is specific to the Siemens control arrangement used on these units.
Signs this part needs replacing
- Display or control panel is blank or intermittent
- Buttons or dials do not respond when pressed
- Fault codes relating to communication between the HMI and PCB
- Visible damage to the cable, insulation or connector ends
- Loose or corroded plug terminals at either board end
Before you order
- Confirm the appliance model and that it uses a Siemens HMI and PCB arrangement
- Check the existing cable's part number or markings against G171
- Inspect both connector ends for pin count and plug orientation
- Verify the fault is in the cable rather than the HMI or PCB itself
Compliance
| Alternative numbers | 1823860 |
|---|
| Make | Model / assembly | Reference | Years | Fitment |
|---|---|---|---|---|
| ANDREWS WATER HEATERS ANDREWS HOT WATER SPARES | — | — | — |
Documents & drawings
Everything we hold for this part. Where a document exists but we don't hold it, the technical team will source it from the manufacturer — usually the same working day.
No documents held for this part. The technical team will source them from the manufacturer — usually the same working day.
No technical questions yet for this part.
Not sure which part?
Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.
