Checking hours…Mon–Fri 7:30am–5pm · Sat 9am–12pm01302 279234Trade account
Alpha 1.030267 InTEC PCB

Alpha

Alpha 1.030267 InTEC PCB

ConditionNew

At a glance

  • Part type: Printed circuit board
  • Also known as ALPHA1.030267
Hanicks code
1.030267
Manufacturer part no.
1.030267
Barcode
8015065044304

The Hanicks code is specific to the selected condition. Manufacturer part no. and barcode are shared by every condition.

Showing prices
Choose condition

£288.00

£240.00 ex. VAT · VAT at 20%

In stock
Delivery
In stock. Order by 4pm Mon–Fri, 10:30am Sat for same-day despatch. Standard delivery usually takes 2-3 working days (Royal Mail Tracked 48).
Hanicks code
1.030267
Not certain it's the right part? The technical team verifies fitment before dispatch — no charge, and it stops a second trip.

Same-day dispatch

Ordered by 4pm Mon–Fri, 10:30am Sat.

30-day returns

Unused, in original packaging.

What it is

The Alpha 1.030267 is a printed circuit board (PCB) supplied by Alpha for use in its heating appliances. The board carries the control electronics that run the appliance's operating sequence, so a failure usually shows up as a loss of function rather than a mechanical fault. It sits in the Alpha spares range under standard water heaters.

Signs this part needs replacing

  • The appliance fails to start or does not run through its full operating sequence
  • No response from the controls, display or status indicators
  • Repeated lockouts that clear only temporarily before returning
  • Temperature control becomes erratic or drifts away from the set point
  • Visible damage on the board, including scorching, corrosion or moisture tracking

Before you order

  • Check the appliance model and serial number against the compatibility data for this part
  • Confirm the part number printed on the existing board matches 1.030267
  • Decide which service route is needed: advanced replacement, direct sale, or repair and exchange

Not sure which part?

Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.