
Halstead
Halstead Potentiometer Complete With Wiring Harness 401104
Halstead potentiometer supplied complete with wiring harness, used on Quattro and Wickes 2000 gas boilers.
At a glance
- Also known as 1291658
£17.71
£14.76 ex. VAT · VAT at 20%
Same-day dispatch
Ordered by 4pm Mon–Fri, 10:30am Sat.
30-day returns
Unused, in original packaging.
What it is
The Halstead potentiometer complete with wiring harness is a control component used on Halstead gas boiler appliances. It provides the variable resistance signal that the boiler's control board reads to set the heating and hot water temperature. The assembly is supplied as a potentiometer with its wiring harness already attached.
Signs this part needs replacing
- The temperature dial turns but the boiler does not respond to changes in setting
- Boiler temperature fluctuates or runs at a fixed temperature regardless of dial position
- The dial feels loose, gritty or has no resistance through its travel
- Heating or hot water temperature cannot be adjusted reliably from the control knob
- Intermittent boiler behaviour that changes when the dial is moved
Before you order
- Confirm your appliance model matches one of the listed fitments
- Check the part number and markings on the existing potentiometer before ordering
- Inspect the harness connector and plug for damage or corrosion
- Isolate the electrical supply to the boiler before removing or fitting the component
Compliance
| Alternative numbers | 1291658 |
|---|
| Make | Model / assembly | Reference | Years | Fitment |
|---|---|---|---|---|
| HALSTEAD QUATTRO | 47-333-01 | 47-333-01 | — | — |
| HALSTEAD QUATTRO GOLD | 47-333-04 | 47-333-04 | — | — |
| HALSTEAD WICKES 2000 | 47-333-03 | 47-333-03 | — | — |
Documents & drawings
Everything we hold for this part. Where a document exists but we don't hold it, the technical team will source it from the manufacturer — usually the same working day.
No technical questions yet for this part.
Not sure which part?
Tell the parts assistant what it's going into — the appliance make and model, or the GC number off the data badge — and it will check this part is on the fit list.
